Wanted 1 conrod nut for 4AGE

P

PDtuning

Sunday Drivers
Iv my engine taken apart, and while wire brushing my conrods on the bench grinder the brush spun of one of the nuts and bing-bing-bing and iv been looking around the garage for 2 days and nothing.

Went to my local engineering shop and they had the right size nut but wrong thread

So if someone has upgraded there rods or has a damaged engine they can take one off, i can send you a few quid :653:

Pete
 
Tryed registering with them before, there a bit picky over who they allow in.

Anyone got numbers for the other 2 guys?
 
Try Tooling & Engineering down in Ballymount.... 01 450 5811... or better known as T.E.D... they do all sorts of nuts... 1.25mm fine thread too which a lot of Japs use. Do you know the thread...?
 
You must log in or register to reply here.
Back
Top