Lamin-X rear tints

Altezza-Dan

Altezza-Dan

Octane Boostaholics
finally got around to fitting these tints to the rear lights. i think they look good

before:


new and old:


After:


Looks well i think, lets hope the stay on for a bit
 
Nice one Dan. I was thinking of doing the same to continue my black light theme. Is it just tinted film you apply to the back of the lens?
 
yep you just put a vinyl film over the lights and slowly start from one corner and work your way across, working all the bubbles out, then trim the edges off. they come pre cut the size of your light, with a few mm each side to play with. if you mess it up just pull it off and start again. Lets 80% of light to pass through so not too dark a tint
 
You must log in or register to reply here.
Back
Top