Right went down to my folks place and had a look in the garage today to see what parts i still have left over from my STI 5
STI fog light covers, silver with pink 'STI' writing
PIAA round Spot lamp covers, white with 'PIAA' written in black ***SOLD***
STI 5 Exhaust manifold and heat shields
WRX standard rear light clusters, yellow indicator
STI5 front indicators and side repeaters, yellow ones
STI 5 Standard Air box and performance air filter, piper one
Billet alloy oil cap
Turbo Dynamics VF24 Ball Bearing Turbo ***SOLD***
WRX low level spoiler, red in colour with centre brake light
STI 5 standard bonnet vents, painted silver
STI 5 standard dump valve and standard pipework
Also have some engine bits from a STI 5, couple of pistons and heat shield bits and hosing
Also have a Autosportif built 2.2 (ej20) engine with no compression in one piston, has the following spec
Baffled Sump
HKS Equal length manifold
STI 5 Flowed Heads
Lightened Flywheel
ARP studs
Cosworth 92.5mm Pistons - Machined for Compression
Competition main end Bearings
Steel Rods
2.2 Crank
i think thats about all the parts i have, i will update the thread if and when i find more bits
Cheers
Alan
More parts just thought of
3 pin Lamda sensor
STI fog light covers, silver with pink 'STI' writing
PIAA round Spot lamp covers, white with 'PIAA' written in black ***SOLD***
STI 5 Exhaust manifold and heat shields
WRX standard rear light clusters, yellow indicator
STI5 front indicators and side repeaters, yellow ones
STI 5 Standard Air box and performance air filter, piper one
Billet alloy oil cap
Turbo Dynamics VF24 Ball Bearing Turbo ***SOLD***
WRX low level spoiler, red in colour with centre brake light
STI 5 standard bonnet vents, painted silver
STI 5 standard dump valve and standard pipework
Also have some engine bits from a STI 5, couple of pistons and heat shield bits and hosing
Also have a Autosportif built 2.2 (ej20) engine with no compression in one piston, has the following spec
Baffled Sump
HKS Equal length manifold
STI 5 Flowed Heads
Lightened Flywheel
ARP studs
Cosworth 92.5mm Pistons - Machined for Compression
Competition main end Bearings
Steel Rods
2.2 Crank
i think thats about all the parts i have, i will update the thread if and when i find more bits
Cheers
Alan
More parts just thought of
3 pin Lamda sensor