prodrive wheel alignment specs

From an older thread

Scoobyke said:
Found these settings

Prodrive Settings

Front camber -1°15’ (-1.25°)
Front toe total 0°00’ (0.00°)
Rear toe 0°06’ (0.1°) per wheel toe in [0°12’ (0.2°) total toe in]

Note: sometimes the front camber figure isn't achievable in which case set it to max. negative equal.
 
settings as above but, push the camber in as far as possible on both sides(front). whichever has the least camber adjust the opposite side to suit. rearly get more than 1.4deg, and it's a good compromise for handling vers wear
 
Back
Top