welding it is the easy job jamie .getting all the bracing right and the feet the right length to support the cars weight is the hard part . turn the welder up loads and when you start blowing holes in the steel turn it down a notch or two and weld away 
.
from experience if your looking to take underseal off or repainting the underside you wont do it properly from under neath the car. i tried it with the grale from under neath and ended up turning it over on its side after removing the doors and putting down an old matress and tyres
.from experience if your looking to take underseal off or repainting the underside you wont do it properly from under neath the car. i tried it with the grale from under neath and ended up turning it over on its side after removing the doors and putting down an old matress and tyres
